Quality Econ P10 Plastic Seat and Back Theater Seats

Quality Econ P10 Plastic Seat and Back Theater Seats

Auditorium Chair for Conference Halls and Theaters ,theater and Opera Chair With Plastic Back and Seat Cover and Plastic Armrest
 

TECHNICAL SPECIFICATIONS

1. The seat part of the seats will have the desired softness and a gravity-centered mechanism that will allow it to close automatically
2. The seats will be ergonomic in shape and appearance, the backrest unit, armrests, seat and foot will be mounted firmly to the seat frame, there will be no shaking or gaps in the connection system.
3. At least Ø16x1.5 mm pipe or at least 15x15x1.5 mm profile material will be used in the metal frames of the seat and backrests.
4. At least three pieces of sheet metal, profile will be welded between the seat frame frames, in the backrests and at least two pieces of sheet metal, profile will be welded in the seats, to increase the strength of the frame.
5. The armrest frames of the seats will be made of at least 40x20x1.5 mm box profile and will be common between the two seats. A plastic armrest resistant to breakage will be mounted on the armrest frame.
Armrests will have an ergonomic structure and appearance.

6. The legs of two-legged seats will be manufactured from 40x60x1.5 mm box profile.

7. The assembly of the seat backs will be made by means of a boltless tight fit method to the mechanism made of Polyamide (PA) material mounted on the legs.

8. The seat legs will be molded from sheet metal with a thickness of at least 2 mm, which can fully touch the ground, and will be able to be fixed to the ground with a total of 4 fastening elements, at least two on each leg.

9. The entire armrest bottoms of the seats made in rows will be open.

10. Plastic plugs will be used to prevent the leg connection bolts of the seats tightened to the ground from being visible.
11. In the seating and backrest units of the seats, 50 ± 10% density cast polyurethane sponge will be used, with the skeletons remaining inside the sponge.
12. The thickness of the thinnest part of the seat and backrest sponges of the seats (both in the seat and the recliner) shall not fall below 3 cm and shall have a hardness that will not cause permanent deformation. The sponge shall be homogeneous and orthopedic throughout the entire surface. The sponges shall have MVSS
302 European standard fireproofing
2/2
13. Fabrics shall be mounted on the seat and back surfaces by gluing

14. A hard plastic polypropylene material with acoustic holes (in the seat and back) shall be used on the back surface of the backrest and the lower surface of the seat

15. There shall be seamless ventilation channels on the backrest surfaces of the seats to prevent sweating

16. The seats shall be fixed with suitable fasteners to the floor. There shall be no shaking or gaps in the seats.

17. All welding processes of the construction shall be made with gas welding and shall be continuous at the joints. The welded seams of the exposed parts in the joints of the steel frame will be on the inner surfaces.

18. The burrs and roughnesses that will occur due to welding on the steel frame of the seat will be ground.

19. The metal parts of the seats will be painted with electrostatic powder paint.